Corrugated Stainless Steel Tubing: A Good Choice for the Short Run PATH Case Study

(Continued from Page 1)

Installation tips "You have to pay attention when you install flex pipe because the pipe has a memory when you uncoil it," Wagner says. "If you get a loop in it, you can't just untwist it to get it straight. It's not like an electrical wire where if there's a little twist in it, you can still make it look good. "CSST is flexible, but it is also sort of thin, so it can kink. You're not supposed to make a sharp 90-degree turn with it. If you do need to make a 90-degree turn, use a fitting. "You have to treat it somewhat like water pipe. You have to protect it wherever it goes through studs and where nails can get to it. But the manufacturer gives you all kinds of stud protective plates." "You also have to make all the other tradesmen aware of the flex pipe because it is more vulnerable than steel," says builder Dave Pusey. "It is possible to put a leak in the CSST pipe with a drywall screw or shoot a nail through it if it's not protected properly, which you don't have to worry about with conventional cast iron pipe." When to use flex pipe "If you only have straight runs in the basement, it probably wouldn't be economical, but flex pipe is a real time saver if you're also roughing gas pipe into the second and higher floors," Wagner says. "If you had to get gas piping up to the third floor of an apartment for a washer and dryer, for example, the time savings would be huge. Once you start going up a wall, across a floor, up another wall, and across another floor with black pipe, you would have all those joints that you're trying to fish-hook a pipe through. That's where you're saving your time with CSST. "Another place where it would be a big time saver would be on a remodel job," says Pusey. "If somebody wants a gas fireplace over in a certain part of the house, flex pipe is going to be so much easier to install because once you get a hold of the end of it, it's almost like you're fishing wire. That makes CSST the least invasive way to install a natural gas line, which homeowners like because it's very economical and clean." Certification "Most manufacturers require certification to install their flex-pipe product," Wagner says. "The supplier gives you a book and tells you about the product, and then they give you a test that's essentially open book. The entire process takes about an hour. It's an easy certification." Technology highlights This project included the following PATH-profiled technologies: Corrugated Stainless-Steel Tubing This article is provided courtesy of PATH — the Partnership for Advancing Technology in Homebuilding. PREVIOUS  1 | 2